This Cisco Learning Network page discusses the use of "switchport mode access" and "nonnegotiate" together for securing a switch port.

Hi Everyone! I would like to know how to connect cisco switch with console port notice am using cisco packet tracer thanks in advance

Ing_Percy schrieb: Hi! The "ip default-gateway x.y.z.w" command is necessary in a Layer 2 switch to management remotely. Without this command, you can't access by telnet/ssh That is not …

When switch 6 distributes the frames out of access ports, they are untagged and can be received by the end points. If the links are in access-vlan ( 2 and 4 ), does traffic not travel tagged?

Hi All, I am facing an issue with a switch. Please refer my below sample diagrams to understand the network setup. Here i am unable to ping or telnet to the SW1 (10.10.172.229). The switch …

Usually an uplink port connects to another switch, while an access port connects to a host. In some switches, such as some of the Nexus 9000 range, there are 4-6 40G ports, and 48 10G …

In this figure, you can find a Core Switch and two Access switches connected to it. There are two end devices PC0 and PC1 connected to Switch A and B respectively.

Explore Cisco's Learning Network for expert discussions and resources on switch distribution layers, network management, and design strategies.

Uplink refers to a link that connects the local box to another device "above" it in the topology. So for instance, the link that connects an access switch to an aggregation level switch would be …

if i have just setup a switch with 2 vlans and and a trunk to my uplink switch which is doing all the inter vlan routing for my hosts giving access to whole network, but i want to manage my new …